242
ESSENTIAL TECHNICAL PARAMETERS
Rear carried machine or front and rear carried combination
1. Calculation of the minimum front axle load GV min
The calculated value of the minimum front axle load should be recorded in the table.
Front carried machine
2. Calculation of the minimum rear axle load GH min
The calculated value of the minimum rear axle load should be recorded in the table.
3. Calculation of the real front axle load Tv tat
If the necessary front axle load cannot be reached with the front attached machine (GV), the weight of the front carried machine
must be increased to the minimum allowed load.
The real values and allowed values specified in the instructions for use of the tractor designed for the front axle should be
recorded in the table.
4. Calculation of the real total load G tat
If the necessary rear axle load cannot be reached with the rear attached machine (GH), the weight of the rear carried machine
must be increased to the minimum allowed load.
The real values and allowed values specified in the instructions for use of the tractor designed for the total load should be
recorded in the table.
5. Calculation of the real rear axle load T h tat
The real values and allowed values specified in the instructions for use of the tractor valid for the rear axle load should be
recorded in the table.
6. Load-bearing capacity of tyres
The calculation of the double value (two tyres) of the allowed tyre load (see, e.g., documents for tyre manufacturers) should be
recorded in the table.
To Next Page
Loading...
Need help?
General