180
MAINTENANCE INSTRUCTIONS
F206
FRONT PTO
The inspection and filling plug of oil (1) is
situated on the front side of the front
PTO case.
Note: A plug or a hollow bolt is used de-
pending on the version.
The front PTO with the standard turning
direction is equipped with a hollow bolt of
the oil cooler hose instead of the inspec-
tion and filling plug. Perform the check
after removing the hollow bolt.
After unscrewing of the inspec-
tion screw the oil level must
reach the bottom edge of the in-
spection opening.
During the oil replacement the oil clean-
ing strainer (2) must be cleaned. The
cleaning strainer is accessible after the
disassembly of the locking ring and re-
moval of the cap.
To Next Page
Loading...
