86
RUNNING IN THE TRACTOR
G251 G252
GENERAL PRINCIPLES FOR RUNNING IN THE NEW TRACTOR IN THE
COURSE OF THE FIRST 100 HOURS OF OPERATION
During the first 100 operation hours:
- Avoid operation under high load of the engine.
- Avoid excessive idle run.
- Frequently check the oil level in the engine (increased oil consumption is normal
in this period).
- Check screw connections mainly of the supporting parts of the tractor.
- Immediately remove all established shortcomings; thus, you will prevent subse-
quent damage and possible impairment of operation safety.
- Proceed in the same way after a general overhaul of the tractor as well.
DURING THE FIRST 10 HOURS
- Run in the tractor in the transport re-
gime.
- Tighten the fitting nuts of the front and
rear wheels, including the bead / rim
connections at the prescribed torque.
To Next Page
Loading...
