11
GB
TOWING
Towing can be done continuously for 8 hours. Check that the oil temperature does not go over 80°C.
The position of the control lever is of no importance when the engine is off.
Do not perform any operations on the transmission during towing, as the propeller may start
turning.
CONTROL VALVE SHIFT CONTROL LINKAGE
When installing the shift control linkage,
make sure the travel on the lever takes it
right to the travel limit, when operated from
the bridge console.
If it doesn't, this could result in the burning of
the clutches because the oil flow rate will be
too low.
Fig. 12
TECHNICAL DATA
2
Notes
* ) gearbox without optionals; (see "oil level check")
**) reference r.p.m: 1500
Use holes [5] and [14], as shown on page 8 and 9, for taking the readings.
You are advised to fit a pressure gauge (range 0-50 bar) into hole [14] and an oil
temperature sensor into hole [5].
SECTION
*Oil capacity Pump delivery **Op.pressure Op.
(dm
3
) (l/min a 1000 rpm) (bar) (°C)
ZF W 325 20 19 20 ÷ 21 40 ÷ 80
ZF 325 7,5 15 23 ÷ 24 40 ÷ 80
ZF 325 A 6,5 15 23 ÷ 24 40 ÷ 80
ZF 325 IV 8 ÷ 9 15 23 ÷ 24 40 ÷ 80
Type
To Next Page
Loading...
Need help?
General
