Zibro P 129 - Operating Modes and Timer Functionality; Cooling Mode Operation Details; Dehumidifying and Air Circulation Modes; Setting the Timer for Operation

4
75
COOLING
When the unit is in the cooling mode, the following functions apply:
• Thefanspeedcanbeadjustedbypressingthe -button
Maximum setting.
Medium setting.
Lowest setting.
• Thetemperaturecanbesetbypressingthe and buttons, anywhere
between 16°C en 32°C. The display will show the set temperature for 15
secondsandthe“settemp”willlightup.Fifteensecondsaftersettingthe
required temperature, the display will show the room temperature.
G
It depends on the environment whether the required temperature will
be reached. It is not a malfunction of the air conditioner if the room
temperatureremainsabovethe“settemp”.
DEHUMIDIFYING
When the unit is primarily used as a dehumidifier, then please follow these
instructions: Do not connect the air exhaust hose and let the warm air go
back into the room. Connect a drainage hose onto the permanent drain
connector on the back of the unit (refer to Chapter G). You must connect a
drain tube to the water outlet 8 (refer to Chapter G).
When the unit is in the dehumidifying mode, the fan speed cannot be
adjustedwhenthetemperatureisbelow25ºC.Thefanspeedwillbe
automatically set on ‘Medium setting’. Adjusting of the temperature setting
does not have any effect when in dehumidifying mode.
AIR CIRCULATION
In this mode the unit only circulates air; the unit will not cool or dehumidify.
The air entering the unit is not cooled or dehumidified, but is filtered.
When the unit is in this mode, the following functions apply:
• Thefanspeedcanbeadjustedbypressingthe-button
Maximum setting.
Medium setting.
Lowest setting.
4
When the unit is switched off the most recent setting will be stored in
memory.
5
The timer function allows you to switch the unit on or off at a certain time.
TO SWITCH ON THE UNIT AT A CERTAIN TIME
• Ensurethattheunitissetintherequiredoperatingmode , of .
• Switchofftheunitbypressingthe -button. Ensure that the plug is
properly inserted into the wall outlet.
• Pressthe -button.Thelight“Timerset”willflash.
• Usethe and buttonstosetatimebetween1and24hours.
• Whenthesettimehasexpiredtheunitwillswitchon.