What to do if my Zibro P 820 Air Conditioner does not function?
If your Zibro Air Conditioner isn't working, first ensure it's properly connected to a functioning power outlet and switched on. If the LCD light is flashing, empty the internal water container. Also, check if the Timer function is active and deactivate it if necessary. Finally, ensure the internal water tank is not full; empty it if it is.
Why is my Zibro P 820 not performing well?
If your Zibro Air Conditioner isn't performing well, check if it's in direct sunlight and close the curtains. Ensure windows and doors are closed, especially if there are many people or heat sources in the room; consider adding another air conditioner. Also, a dirty filter can impact performance, so clean or replace it. Make sure the air inlet and outlet are not blocked, and adjust the temperature setting if it's lower than the room temperature.
What to do if my Zibro P 820 remote control does not function?
If the remote control for your Zibro Air Conditioner isn't working, make sure you're aiming it correctly at the control panel and that you are not too far from the unit. If that doesn't solve the issue, replace the batteries in the remote.
Why the compressor does not work in my Zibro P 820?
If your Zibro Air Conditioner's compressor isn't working, it's possible the overheat protection has been activated. Wait 3 minutes to allow the temperature to decrease, then try turning the unit on again.
How to fix a noisy Zibro P 820?
If your Zibro Air Conditioner is making excessive noise, ensure it is placed on an even surface to reduce vibrations.
Connect the unit to the main power supply and switch it on.
Procedure to set the current time on the LCD display.
How to adjust the set temperature up or down.
General| Refrigerant | R290 |
|---|---|
| Type | Portable |
| Cooling power | 2.05 kW |
| EER | 2.6 |
| Cooling Capacity | 2.3 kW |
| Energy Efficiency Ratio (Cooling) | 2.6 |
| Operating Temperature (Cooling) | 17-35 °C |
To Next Page
