EasyManua.ls Logo

Zibro P 332 - Page 9

Zibro P 332
16 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
4
69
DEHUMIDIFYING
When the unit is primarily used as a dehumidifier, then please follow these
i
nstructions: Do
n
ot
c
onnect the air exhaust hose and let the warm air go
back into the room. You must connect a drain tube to the water outlet
8
(refer to Chapter G).
When the unit is in the dehumidifying mode, the fan speed cannot be
a
djusted. The buttons and can also not be adjusted.
AIR CIRCULATION
In this mode the unit only circulates air; the unit will not cool or dehumidify.
The air entering the unit is not cooled or dehumidified, but is filtered.
When the unit is in this mode, the following functions apply:
The fan speed can be adjusted by pressing the -button
Maximum setting.
Medium setting.
Lowest setting.
The timer function allows you to switch the unit on or off at a certain time.
TO SWITCH ON THE UNIT AT A CERTAIN TIME
Ensure that the unit is set in the required operating mode , or .
Switch off the unit by pressing the -button. Ensure that the plug is
properly inserted into the wall outlet.
Press the -button.
Use the and buttons to set a time between 1 and 12 hours.
When the set time has expired the unit will switch on.
TO SWITCH OFF THE UNIT AT A CERTAIN TIME
When the unit is operating in the required mode press the -button.
Use the and buttons to set a time between 1 and 12 hours.
When the set time has expired the unit will switch off.
G
NOTE!
The compressor has been set so that it starts functioning three minutes
after the (re)start of the air conditioner
.
The cooling will switch off when the room temperature is lower than
the set one. Air circulation will however continue to work on the set
level. When the room temperature rises above the selected value, the
cooling will work again.
4
man_P3xx_1 19-04-2007 13:26 Pagina 69

Related product manuals