MANUAL
A INSTALLING THE HEATER
Carefully remove your Zibro heater from the box and check the contents.
I
n addition to the heater you also need to have:
E a manual fuel pump
E a transportation cap
E these directions for use
Keep the box and the packaging materials (Fig. A) for storage and/or transportation.
Remove the other packaging materials:
E Remove the packaging material from the grill G. Lift the grill from the slot
(Fig. B) and pull it forward.
E Push the packing material on top of the combustion chamber D slightly
down and remove it (Fig. C). Remove the packaging materials from under
the combustion chamber as well (Fig. D).
E Put the combustion chamber back into its place. The combustion chamber
is positioned correctly when it can be smoothly moved a little to the left
and to the right by its handle
E (Fig. E). Close the grill: Slightly lift it to
reposition it in its slot.
E Open the lid for removable tank H and remove the piece of cardboard.
Fill the removable tank as indicated in
Section B.
Insert the batteries into their holder L at the back of the heater (Fig. F).
Ensure that the positive and negative poles match the + and - marks indicated
on the battery housing.
The floor should be firm and completely level.
Your heater is now ready for use.
B FILLING FUEL
Do not fill the removable tank in the living room, but in a more suitable place
(there can always be some spillage). Follow the procedure below:
Make sure that the heater is switched off.
Open the lid
H and lift the removable tank I out of the heater (Fig. G).
Note: Some dr
ops may leak from the tank. Put down the removable tank
(cap pointing upwards) and screw off the fuel cap.
To Next Page
Loading...
