ZiLOG System 8000 User Manual

USER
27
QUIT
Syntax
QUIT
Description
Zilog USER
The QUIT command is used to enter Transparent Mode from Mon-
itor Mode. In Transparent Mode, all keyboard inputs and
console outputs are passed between the remote computer sys-
tem and the S8000. The console controls the remote computer
system's operating system. Channels A and B of the SI02
must be set to the same baud rates when operating in Tran-
sparent Node.
The START switch on the S8000 is used to return to Honitor
f'lode.
SIO PORT
Syntax
PORT <port addressw> [WIB]
Description
The PORT command is similar to the IOPORT command; hmqever,
it is used to read data from a Z80l0A MHU.
TEST
Syntax
TEST
Description
The TEST command executes the S8000 standalone diagnostic
tests.
Example
~ (CR)
ZBOOT
Syntax
ZBOOT [DIT]
Description
This command is commonly used to manually bootstrap the ZEUS
Operating System. The ZBOOT command reads a 5l2-byte pro-
gram from block 0 of the disk or the cartridge tape drive.
Generally, there is no return to the Monitor.
Zilog
27

ZiLOG System 8000 Specifications

General

Brand	ZiLOG
Model	System 8000
Category	Desktop
Language	English