ZiLOG System 8000 User Manual

USER
28
Zilog
USER
Example
.z..! (CR)
3.3.2 Upload/Download Mode Commands
Summary
of Commands in Upload/Download Mode
PARAMETER
LOAD
<filename>
Load S/W from S8000 system
NOTE
Filenames can be specified in either upper or
lowercase. They can be full path names. LOAD
only loads data into segment O.
Upload/Download Mode transfers data between the S8000 and a
remote computer system. Channels A and B of the SI02 must
be set to the same baud rates when operating in
Upload/Download Mode. The LOAD program is required on the
remote system to perform upload/download functions through
console I/O.
The Upload/Download Mode uses the Tektronix record format,
which uses only ASCII characters. Each record contains two
checksum values, a starting address, and a maximum of 30
bytes of data. The format of the record is:
RECORDS 1 to n
/
<address(4» <count(2» <checksuml(2» <data(2» •••
<data(2» <checksum2(2» <carriage return>
where:
<address(4»:
<count(2»:
<checksuml(2»:
is the address
data in the
represented in
ters)
of the first byte of
record (address is
four ASCII charac-
is the number of <data> in current
record (two ASCII characters)
is the checksum for the address and
count field (two ASCII characters)
Zilog
28

ZiLOG System 8000 Specifications

General

Brand	ZiLOG
Model	System 8000
Category	Desktop
Language	English