ZiLOG System 8000 User Manual

USER
30
Zilog
USER
remote system if the escape (ESC) key is pressed, aborting
the loading process. The Monitor Program then returns to
Monitor Mode for the next command. The address used in the
data record during the loading process is provided by the
file description record; it must be greater than %4000
(%2000 through %4000 are used by the Monitor Program).
COMMAND DESCRIPTION
LOAD
Syntax:
LOAD <filename>
Description:
This command downloads a Z8000 program named <filename> that
resides in the remote system.
The Moniter Program transmits the exact command line to the
remote system. The command causes a remote procedure file
(LOAD) to be executed, to open the file specified by
<filename>. The binary data in the file is converted to
Tektronix record format and transmitted to the S8000.. The
Monitor Program verifies the two checksum values in the
receiving record and stores the data in RAM memory as speci-
fied by the address indicated in the record. An acknowledg-
ment from the S8000 causes the next record to be downloaded
from the remote system. A nonacknowledgment from the S8000
causes the current record to be retransmitted up to ten
times, after which a record with an error message is sent,
and the Monitor Program returns to Monitor Mode. The LOAD
program in the remote system is also aborted. When the
loading process is completed, the entry point received on
the first record is displayed. Pressing ESC aborts the LOAD
command. Any breakpoints set from a previous program must
be cleared before a new program is loaded from the remote
system.
Zilog
. 30

ZiLOG System 8000 Specifications

General

Brand	ZiLOG
Model	System 8000
Category	Desktop
Language	English