Zip'r PC - Batteries and Charging Continued: Requirements; Step 6: Battery Removal; Battery Installation Requirements

29 pages

To Next Page

To Previous Page

WARNING REQUIRED

BATTERY INSTALLATION REQUIREMENTS

• Use only sealed U1 type batteries in your Zip'r PC.

• Ensure that the positive (+) red cable and the negative (-) black cable for

the rear battery are installed only on the replacement rear battery. Ensure

that the positive (+) red cable and the negative (-) black cable for the front

battery are installed only on the replacement front battery.

• Always replace both front and rear batteries (never just replace one

battery).

BATTERIES AND CHARGING CONTINUED

Step 6:

Using the battery handles, remove each

battery from the Zip'r PC.

Reinstall/replace batteries in the

reverse order of these directions.