EasyManuals Logo

Zip'r PC User Manual

Zip'r PC
29 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #19 background imageLoading...
Page #19 background image
19
WARNING
CHARGING BATTERIES
NEVER attempt to recharge the batteries by attaching charging cables directly to
the battery terminals.
NEVER attempt to recharge the batteries and operate the wheelchair at the
same time.
NEVER attempt to recharge the batteries when the wheelchair has been
exposed to any type of moisture.
NEVER attempt to recharge the batteries when the wheelchair is outside.
NEVER sit on the wheelchair while recharging the batteries.
ALWAYS charge new batteries before initial use or battery life will be reduced.
NEVER use a charger not approved or supplied by Zip’r Mobility.
1. Attach the battery charger connector to the charger port on the front of the
joystick.
2. Plug the chargers’s AC power cord or extension into the grounded 110-
volt wall outlet.
3. When charging is complete, turn the charger off.
4. Disconnect the output cable from the charger port.
BATTERIES AND CHARGING CONTINUED

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Zip'r PC and is the answer not in the manual?

Zip'r PC Specifications

General IconGeneral
Weight Capacity300 lbs
Overall Length40 inches
Seat Width18 inches
TypePower Wheelchair
Battery24V