Figure 6. Loosen tiller adjustment knob, raise the tiller to the
desired angle, and retighten the tiller adjustment knob. Unlock the
tiller lock located at the bottom front of the scooter tiller by pushing
and turning the knob. ( WARNING! The mobility scooter will not
turn if the lock is not released. The tiller lock should only be locked
during transportation).
Figure 7. Carefully place the battery box into the battery compartment.
Lightly press down on the front and rear of the battery box to ensure
that the front and rear connections have fully engaged.
Figure 8. Insert the chrome seat post extension into the seat post.
Insert the seat post pin in at the desired height.
Figure 9. Install the seat by lowering the seat into the seat post
extension, rotating it until it locks into position facing towards the
tiller.
NOTE: To use the swivel seat function pull on the lever (located at
the right of the seat).
Figure 10. The fully assembled Zip’r Traveler mobility scooter.
Disassembly of your scooter can be accomplished by following
the above steps in reverse order.
To Next Page
Loading...
Need help?
General
