DATA1
DATA0
GND
+12V
GLED
RLED
BEEP
485+
485-
RXD
TXD
GND
GND
WD 0
WD 1
DATA0
GND
DATA1
Access Control
IWD1
12Vout
BEEP
GLED
RLED
IWD0
GND
IP Address：192.168.1.100
Subnet Mask：255.255.255.0
IP Address：192.168.1.124
Subnet Mask：255.255.255.0
Switch
PC
…
Side View Back View
Tamper Switch
Reset Button
(1) RS232 Mode:
Terminals:
RXD Pin3-Txd
TXD Pin2-Rxd
GND Pin5-Gnd
485+ RS485+
485- RS485-
485+
485-
485+ 485-
RS485 Bus
485+ 485- 485+ 485-
RS485
10. Cautions:
6. Wiegand Output
The device supports standard Wiegand 26 output,
as a reader device it has a very good compatibility.
7. Wiegand Input
connect with card reader. Theyan independent are installed each
The device has the function of Wiegand input upports to signal . It s
Wiegand signal extender in long distance or interference environment).
(2) To keep the stability of Wiegand signal, connect the device and the Access Control or Card Reader in same ‘GND’
(1) Please keep the distance between the device and Access Control or Card Reader less than 90 meters(Please use
There are three modes that the PC software communicate
and TCP/IP, and the last two mode support remote control.
9. Communication
8.Other Functions
(1) Manual Reset:
(A) Crossover cable: The device and PC connected
(B) Straight cable: The device and PC connected to
(3) TCP/IP Mode:
(2) RS485 Mode:
other restart it.abnormality, you can use ‘Reset’ function to
hole with than 2mm).a sharp tool (the tip diameter less
Operation: Remove the black rubber cap, then stick the Reset button
If the device does not work properly because of misoperation or
Terminals PC Serial Ports
(2)We recommend the 3A/12V DC Power supply. Please contact our technical staff for details.
(5)Please connect the ‘GND’ before all the other wiring especially under the environment, to prevent the overlarge
( )3 Please read the terminals description and wiring by rule strictly. Any damage caused by impropercarefully
(4)Keep the exposed part of wire less than 5mm, to avoid unexpected connection.
(6)Do not change the cable type because of long distance between the power and the device.
(1)Power cable is connected after all the other wiring. If the device is working abnormally, please shut down the power
first, then make the necessary check . Kindly reminds you that any hot-line work may damage the device, and
operations will not under warranty.
it is not included in the warranty.
Terminals PC Serial Ports
Converter
！
Warning: No operating with power on
in any case.
side of the door, to control the lock and access together.
Please use specified RS485 wire, RS485 active converter and
bus-type wiring.
and exchange information with the device: RS232, RS485
Terminals:
LAN/WAN through switch/Lanswitch.
directly.
(7) Please use specified RS485 wire, RS485 active converter and bus-type wiring.
instantaneous electrostatic to damage device.
(2) Tamper Switch
When the device is being dismantled, it will send an alarm
signal through the terminal.
To Previous Page
Loading...
Need help?
General
