ZKTeco X7 - Access Control Management - Password Settings; Set;Change Eight Passwords for Opening the Door; Access Control Management - Unlocking Duration; Configure Unlocking Duration

10
2. Access Control Management
2.1 Set/Change Eight Passwords for Opening the Door
1. The administrator
password is authenticated.
2. Press 3.
(The indicator turns green
and makes a long beep.)
3. Enter the password ID of
the to-be-changed
password.
(The password ID ranges
from 1 to 8.)
5. Enter the new password
again for authentication.
4. Enter a new password.
(The password consists of
four digits.)
6. The password is changed.
(The device indicator turns
green and the device makes
a long beep.)
7. Exit.
(Press * or to exit)
YES
Failed.
(The indicator turns red
and makes three beeps.)
Note: 1. The initial eight passwords for opening the door is empty.
2. If a password is successfully changed, enter the password ID of the
to-be-changed password to change the next password.
2.2 Configure Unlocking Duration
1. The administrator
password is authenticated.
2. Press 4.
(The indicator turns green
and makes a long beep.)
3. Enter the unlocking
duration.(range: 0 to 255)
5.Exit.
(The device automatically
exits the process when the
operation is completed.)
4. The unlocking duration is
modified.
(The indicator turns green
and makes a long beep,
then turns red and makes a
long beep again.)
Note: 1. Three-digit values are automatically verified. For values with less than
three digits, press # to enter the verification process. Values greater than 254 are
considered invalid.
Поставщик систем безопасности: TELECAMERA.RU