ZKTeco X7 User Manual

11
2. The indicator turns red and makes a long beep in fourth step indicates system
exits when setting successfully.
2.3 Configure Authentication Mode
1. The administrator
password is authenticated.
2. Press5.
(The indicator turns green
and makes a long beep.)
3. Enter the authentication
mode.
5.Exit.
(The device automatically
exits the process when the
operation is completed.)
4.The configuration is
successful.
(The indicator turns green
and makes a long beep,
then turns red and makes a
long beep again.)
Note: 1.The indicator turns red and makes a long beep in fourth step indicates
system exits when setting successfully.
2. Details about the authentication mode are as follows:
Authentication Mode
type
Description
Mode 1 (number1)
PW
Only password verification
Mode 2 (number2)
RF
Only RF Card verification
Mode 3 (number3)
FP
Only fingerprint verification
Mode 4 (number4)
FP/PW/RF
fingerprint or password or RF verification
Mode 5 (number5)
RF&PW
RF and password verification
Mode 6 (number6)
FP&PW
fingerprint and password verification
2.4 Configure Concealed Mode
If the Concealed mode is enabled, the indicator is off when the Concealed mode
is in the sleep mode.
Поставщик систем безопасности: TELECAMERA.RU

ZKTeco X7 Specifications

General

Brand	ZKTeco
Model	X7
Category	Gateway
Language	English