Need help?Do you have a question about the ZKTeco C3-100 and is the answer not in the manual?
General| Type | Basic access control reader |
|---|---|
| Access code reader | No |
| Fingerprint reader | - |
| Authentication type | Access chip/card |
| Access chip/card reader | Yes |
General guidelines for safe equipment operation and maintenance procedures.
Precautions for safe and correct installation to ensure system integrity and user safety.
Overview of the access control system's capabilities, features, and operational parameters.
Detailed specifications, environmental limits, and electrical characteristics of the control panel.
Explanation of the status indicators (LEDs) on the control panel and their operational meanings.
Step-by-step instructions for physically mounting the control panel's enclosure.
Guidelines for proper wiring and cable management for the access control panel.
Visual representations of system configurations for various door setups.
Identification and connection details for all terminals on the control panel, including model variations.
Procedures for connecting door sensors, exit switches, and auxiliary input/output devices.
Instructions for connecting Wiegand interface card readers to the control panel.
Configuration for connecting control locks and auxiliary outputs via relays in dry and wet modes.
Diagram illustrating the system's power supply architecture, including backup and distribution.
Specifications for network cables and best practices for wiring to ensure reliable communication.
Setup and configuration for network communication via TCP/IP Ethernet.
Setup and configuration for network communication via RS485 serial bus.
Guide to configuring DIP switches for device addressing, factory resets, and terminal resistance.
To Next Page
