Connection and Installation
- 9 -
3.2 Installation of Access Control Operator Panel
Wires
220V input
TCP/IP network communication wire
RS485 network
communication wire
C3 access control
operator panel
Ceiling
Door sensor
Electronic lock
Exit button
Outdoor Wiegand
card reader
Indoor Wiegand card reader
Outdoor
Indoor
Figure 3-1 Access Control Operator Panel Wire Installation Diagram
Notes:
1. Before connection, make sure the power supply is disconnected, because
connection with power connected will cause severe damage to the equipment.
2. The access control wires must be separated according to heavy and light
current; the control panel wires, electronic lock wires, and exit button wires
must run through their respective casing pipes.
To Next Page
Loading...
