ZKTeco X7 User Manual

12
1. The administrator
password is authenticated.
2. Press０.
(The indicator turns green
and makes a long beep.)
３．Press３.
(The indicator turns green
and makes a long beep.)
5. The configuration is
successful.
(The indicator turns green
and makes a long beep,
then turns red and makes a
long beep again.)
４.Configure the concealed
mode
(0: enable; 1: disable).
6.Exit.
(The device automatically
exits the process when the
operation is completed.)
Note: 1.An indicator blinks to indicate the status of this function when users
are authenticating their cards or fingerprints.
2. The indicator turns red and makes a long beep in fifth step indicates system
exits when setting successfully.
2.5 Configure Door Sensor Mode
The door sensor switch includes three modes:
 NONE: The door sensor switch is not used.
 NO: The lock is open as long as the door is open.
 NC: The lock is closed after the door is closed.
1. The administrator
password is authenticated.
2. Press０.
(The indicator turns green
and makes a long beep.)
３．Press 5.
(The indicator turns green
and makes a long beep.)
5. The configuration is
successful.
(The indicator turns green
and makes a long beep,
then turns red and makes a
long beep again.)
４.Configure the door
sensor mode (0: enable;
1: disable; 2: without door
status sensor).
6.Exit.
(The device automatically
exits the process when the
operation is completed.)
Note: 1.The door sensor mode configured here is used as the basis for the
door sensor alarm.
2. The indicator turns red and makes a long beep in fifth step indicates system
exits when setting successfully.
Поставщик систем безопасности: TELECAMERA.RU

ZKTeco X7 Specifications

General

Brand	ZKTeco
Model	X7
Category	Gateway
Language	English