ZKTeco X7 User Manual

4
Instructions
Recommended Procedure:
Step 1: Install the device and power on.
Step 2: After the administrator password is authenticated and changed, register
users' fingerprints, cards, or passwords.
Step 3: Configure access control parameters, including modifying eight
passwords for opening the door and configuring the unlocking duration,
authentication mode, stealth mode, door status sensor mode, and alarm.
Functions of the Device
∣―1.User Management
∣ ∣―1.1 Administrator Operations
∣ ∣ ∣― Administrator Authentication
∣ ∣ ∣― Change Administrator Password
∣ ∣ ∣― Open the Door by the Administrator Password
∣ ∣ ∣― Administrator Password Be Forgotten
∣ ∣―1.2 Add Users
∣ ∣ ∣― Add Users
∣ ∣ ∣― Register Cards in Batches
∣ ∣―1.3 User Authentication
∣ ∣―1.4 Delete Users
∣ ∣ ∣― Delete a User
∣ ∣ ∣― Delete All Users
∣―2.Access Control Management
∣ ∣―2.1 Set/Change Eight Passwords for Opening the Door
∣ ∣―2.2 Configure Unlocking Duration
∣ ∣―2.3 Configure Authentication Mode
∣ ∣―2.4 Configure Concealed Mode
∣ ∣―2.5 Configure Door Sensor Mode
∣ ∣―2.6 Configure Alarm
∣ ∣ ∣― Configure Alarm setting
∣ ∣ ∣― Configure Error Operation-Triggered Alarm
∣ ∣ ∣― Configure Tamper Alarm
∣ ∣ ∣― Configure Alarm Delay for the Door Status Sensor
Поставщик систем безопасности: TELECAMERA.RU

ZKTeco X7 Specifications

General

Brand	ZKTeco
Model	X7
Category	Gateway
Language	English