ZKTeco X7 User Manual

5
Operation Instructions
1. User Management
1.1 Administrator Operations
To ensure data security of the device, you can operate the device only after the
administrator password is authenticated.
 Administrator Authentication
1. Press [*]
(The indicator is off and
makes a long beep.)
2. Press[ #].
(You can authenticate the
password.)
3. Enter the administrator
password.
(The initial password is
1234.)
5. Exit.
(Press * or do not operate
the device within 20
seconds.)
4. The authentication is
successful.
(The indicator turns green.)
Note: The initial administrator password is 1234. You are advised to change
the initial password at the beginning.
 Change Administrator Password
1. The administrator
password is authenticated.
2. Press 8.
(You can change the
password.)
3. Enter a new
administrator password.
YES
5. Succeeded.
(The indicator turns
green and makes a long
beep.)
4. Enter the new
administrator password
again for authentication.
6. Exit.
(The device automatically
exits the process when the
operation is completed.)
Failed.
(The indicator turns red
and makes three
beeps.)
Note: Four-digit passwords are automatically verified. For passwords with less
than four digits, press # to enter the verification process.
 Open the Door by Entering the Administrator Password
Поставщик систем безопасности: TELECAMERA.RU

ZKTeco X7 Specifications

General

Brand	ZKTeco
Model	X7
Category	Gateway
Language	English