Zline DW-WM-18 Manual

22
Troubleshooting
TROUBLESHOOTING
CODE ERROR MESSAGE POSSIBLE REASON
E1
During the water inlet step,
if the flow meter can’t detect
the water after 4 minutes,
the dishwasher will display
an E1warning.
1. Check the water supply
2. Check the inlet valve
3. Check the inlet
4. Check the flow meter
5. Check the pressure switch
6. Check the drain
7. Check the PCB
See more detailed instructions on
page 24.
E3
(Only appears in the
factory mode)
When the temperature
can’t reach the defined
temperature after 90
minutes, the dishwasher will
display an E3 warning.
1. Check the heater
2. Check the thermistor
3. Check the PCB
E4
When the water floods
into the bottom of unit
and activates the flood
microswitch, the dishwasher
will display an E4 warning.
1. Check the use of the detergent
2. Check whether the appliance is
level
3. Check the micro-switch
4. Check the drain pump
5. Clear drain hose from any
obstruction
6. Check the amount of the filled
water
7. Find where leakage is
8. Hard reset (turn the breaker off for
10 seconds and turn it back on)
OR
1. Remove the base board
2. Remove the switch at the base
board
3. Lift up the dishwasher
4. Find where the leakage is.
5. Hard reset (turn the breaker off for
10 seconds and turn it back on)

Zline DW-WM-18 Specifications

General

Style	built-in dishwashers
Color	white matte, matte white
Load Capacity	16
Number of Cycles	6
Options/Settings	energy save, quick wash, normal, rinse, eco wash, heavy wash, sanitary, high temperature wash, glass, heat dry option
Drying Type	heated drying
Noise level	40 decibels adjusted
Control Type	touchpad
Delay Start	yes
Number of Racks	2
Sanitize Settings	no
Annual Energy Consumption	234 kilowatt hours
Voltage	120 volts

Weight and Dimensions

Depth	23 inches
Height	32 1/2 inches
Width	17 3/4 inches
Net Weight	73.7 pounds