43
If overflow occurs, turn off the main water supply before calling a
service.
If there is water in the base pan because of an overfill or small leak,
the water should be removed before restarting the dishwasher.
Troubleshooting
WARNING
during the water inlet step, if the flow
meter can't detect the defined water
after 4 minutes, the dishwasher will
warning for E1.
(only appeared in the factory mode)
when the temperature cant reached
the defined value after 90 minutes, the
dishwasher will warning for E3.
the water flood into the bottom and
result in the detective switch moves,
the dishwasher will warning for E4.
(only appeared in the factory mode)
E6 - thermal sensor cut.
E7 - thermal sensor short.
If pushing one buttom for more than
30s, the dishwasher will warning for
E9
If the Dashboard detect
communication data is abnormal for
more than 30s, the dishwasher will
show a warning for Ed
1. check the water supply
2. check the inlet valve
3. check the inlet
4. check the flowmetre
5. check the pressure switch
6. check the drain
7. check the PCB
1. check the heater
2. check the thermistor
3. check the PCB
1. check the inlet water
temperature
2. check the thermistor
3. check the PCB
Buttom sticks,warning resovlved
when releasing the buttom
communication data abnormal,
warning resovlved when
communicate data return to
normal.
1. check the use of the detergent
2. check whether the appliance
is level
3. check the micro-switch
4. check the drain pump
5. check the amount of the filled
water
6. find where leakage is
Error Codes
When some malfunctions come on, the appliance will display error codes to warm
you.
Symptom
Error Message
Possible Reason
E1
E3
E4
E6
E7
E9
Ed
To Next Page
Loading...
Need help?
General
Weight and Dimensions
