19
Crisper Drawers
CRISPER COMPARTMENT
To remove the crisper
• Pull the crisper out until it stops.
• Doors must be fully opened to remove/install the crisper.
• Slightly unclip the front section of the drawer and take it out completely.
To install the crisper
• Pull the sliding rails out completely (see Figure 1).
• Using care to not scratch the inside of the refrigerator, place the gaps located at the bottom
rear corners of the crisper onto the small extension pieces located at the rear corners of
both rails (see Figure 2, red arrow).
• Push the crisper down until you feel the front section clip onto the rails (see Figure 3).
Figure 1 Figure 2 Figure 3
ATTENTION
Make sure that the small extension pieces located on the rails at the right and
left-hand sides are affixed when installing the crisper.
OPERATION
To Next Page
Loading...
