15
using the cooktop
RESIDUAL HEAT INDICATOR
• After using the cooktop, the cooking area will remain hot for a few minutes. The
digital display will show an “H” to warn the user that the surface is hot to touch.
Wait until the “H” is no longer displayed to clean the unit. You may turn the
cooktop on even if the “H” is displayed.
SET TIMER
• A short key press adjusts the time by 1 minute and a long key press by 10
minutes. The automatic timer range from 1 minute - 99 minutes. This is used to
automatically turn off the cooktop.
• NOTE: Seconds are not used in the timer settings.
• The red dot next to the time symbol indicator will illuminate indicating that the
cooking elements is selected.
• TO SET
• While cooking, touch the timer key pad until the time light of the desired
cooking element is on. Time digital displays read “00” and blinking.
• Use “+” or “-” key to adjust and set the desired time.
• The timer will begin 5 seconds after setting the timer.
• The display will stop blinking and will stay static on the display.
• The cooking element that the timer was set on will automatically shut off
once time runs out.
To Next Page
Loading...
General