GLASS SHELVES
To remove a shelf
• Fully open the upper door of the refrigerator or both doors to gain better access.
• Hold the front of the shelf, and then gently lift up and slide out (see Figure 1).
To reinsert
• Hold the shelf at an angle so the front is higher than the back, and then insert the top hook
into the top shelf notch (see Figure 2).
• Put down the front slightly to lock into place.
Note: Use care when handling glass shelves to prevent breakage or
scratching the interior.
ATTENTION
Glass shelves must be unloaded when removing and reinstalling.
ATTENTION
You must wait for the glass shelves to reach room temperature before
immersing them in water for cleaning, or you run the risk of the glass
cracking or breaking.
ATTENTION
You cannot close the refrigerator's door(s) if the door bins are
positioned at the same level as glass shelves. Make sure that the
door is closed after placing the shelves.
18
Glass Shelves
OPERATION
Figure 1 Figure 2
To Next Page
Loading...
