Zline RFM-W Series - Crisper Compartment; Crisper Compartment Tips

19
CRISPER COMPARTMENT
To remove the crisper
• Pull the crisper out until it stops.
• Doors must be fully opened to remove/install the crisper.
• Slightly unclip the front section of the drawer and take it out completely.
To install the crisper
• Pull the sliding rails out completely (see Figure 1).
• Using care to not scratch the inside of the refrigerator, place the gaps located at the bot
-
tom rear corners of the crisper onto the small extension pieces located at the rear corners
of both rails (see Figure 2, red arrow).
• Push the crisper down until you feel the front section clip onto the rails (see Figure 3).
ATTENTION
Make sure that the small extension pieces located on the rails at the
right and left-hand sides are affixed when installing the crisper.
19
Crisper Drawers
OPERATION
Figure 1 Figure 2 Figure 3