ZLT X100 PRO - 4.3 Log in to the data terminal; After the computer obtains the IP address, enter u; 5.Configure Data Terminal; When configuring the data terminal, please make su

acquisition method is set to "obtain an IP address automatically".
4.3 Log in to the data terminal
After the computer obtains the IP address, enter user name and
password found at the bottom of the device to access the data
terminal configuration page, which is the web management page.
The factory default user name and password for the data terminal
can also be obtained from the information provided at the bottom
of the device.
5. Configure Data Terminal
When configuring the data terminal, please make sure that the
data terminal is working normally and the computer is connected to
the data terminal. Then log in to the web management page to
configure. Please carefully configure some parameters on the web
management page according to the operator's recommendations.
Improper configuration may result in inability to access the Internet.
Primary
menu
Secondary
menu
Operational instructions
System Status
WAN
Information
You can check WAN wireless
information,network
parameters,signal strength,APN
information and neighborhood
information.
DHCP
Information
View the DHCP status and list of
connected devices on the LAN
side.
2.4G WiFi
Information
View 2.4G WiFi network
information and user
information.
5G WiFi
Information
View 5G WiFi network
information and user
information.
Device
Information
View device running status,
memory usage, etc.
Internet
Function
Network
Setting
Set the network mode and
configure network:flight