You can set the WiFi TX power,
channel, WiFi mode,bandwidth,
and maximum number of
connected users.
Set IP address management on
the LAN side.
Design parameters such as
static routing.
Enable and configure the VPN.
Port filtering: set the port
number to be filtered.
IP address filtering: set the IP
address to be filtered.
MAC address filtering: set the
MAC address to be filtered.
Set the website addresses that
need to be filtered.
Set binding IP and MAC
address.
Modify password: modify the
password for logging in to the
terminal configuration page.
Time setting: set the terminal
system time.
Restore factory settings: restore
the terminal to factory settings.
Intelligent Restart: customize
the restart time.
System debugging information