Fasten the mounting bracket onto the wall,
and connect the wires to the wire terminals.
Feed the two wires from Step 1 through
either one of the large openings in the
mounting bracket.
4
Using the appropriate wall anchors and
screws, fasten the mounting bracket onto
the wall. Then, fasten the two wires to the
terminals on the bracket by tightening the
screws (you can fasten the wires to either
terminal).
Note: When mounting on brick, concrete or
stucco, use the provided screws with anchors.
When mounting on wood or vinyl, drill he
surface.
To Next Page
Loading...
Need help?
General