Zodiac Pool Systems X7 Quattro User Manual

Congratulations!
You have just acquired the Zodiac X7 Quattro.
Thank you for purchasing our product.
Please read this user manual carefully and follow
he instructions for assembly.
PARTS LIST 15
ADVICE 15
ASSEMBLY 15
FITTING THE HOSE 16
CONNECTION 17
FLOW TEST 19
CLEANING THE LEAF TRAP 20
PROBLEM SOLVING 21
CHANGING THE DIAPHRAGM 22
GUARANTEE 24
Contents
1 4
Notice X7 ANG.qxd 9/12/08 10:31 Page 3

Zodiac Pool Systems X7 Quattro Specifications

General

Cable Length	60 ft
Pool Type	In-ground
Power Source	Electric
Warranty	2 years
Pool Surface Compatibility	Concrete, tile, vinyl, and fiberglass

Summary

Parts List

Fitting the hose

Connection

CONNECTING TO THE VACUUM POINT OR TO THE SKIMMER

Ensure all connection elements (leaf trap, flow control valve) remain underwater to prevent air entry.

Problem solving

X7 Quattro is not operating correctly

Check flow tester, main drain, skimmer, hose, and automatic valve for proper function.

The X7 Quattro doesn't clean all the zones of your swimming pool

Split filtration time, check hose length, and orient inlet jets for full pool coverage.

The X7 Quattro does not stay on the bottom of the pool

Adjust hose float position and test/increase flow rate for optimal pool floor contact.

The X7 Quattro stays stuck at the stairs of your pool ladder

The X7 Quattro moves slowly and air bubbles form at the level of the suction outlet

The X7 Quattro moves above the waterline

The X7 Quattro stays stuck at the main drain plug

Changing the Diaphragm

1st step: removing the Diaphragm

Remove hose, push handle clips up, pull handle down, then remove the cleaner case.

2nd step: fitting the new Diaphragm

Place new diaphragm, align notches, pull handle, reassemble case and housing.