Zodiac CADET SOLID 285 - Inflation; Inflate Main Buoyancy Tube; Inflate Keel (Cadet Solid)

/ 10
E
N
G
L
I
S
H
7
INFLATION
Activate all valves into inflation position.
Fit the hose to the foot-pump.
To inflate your boat properly, the bottom side of
the foot-pump must rest on a flat ground.
Pump evenly to inflate rapidly.
CAUTION
DO NOT USE A COMPRESSOR OR A BOTTLE OF COMPRESSED AIR
You can use the electrical air pump ACCESS (ask your Dealer).
TO INFLATE THE MAIN BUOYANCY TUBE
• Insert the pump hose end piece
• Inflate (pressure = 240 mb, refer to PRESSURE section) making sure that each compartment is
equal. When correctly inflated, the internal bulkheads (a) are not visible.
NEVER COMPLETELY
INFLATE A
COMPARTMENT TO FULL
PRESSURE IF OTHER
COMPARTMENTS ARE
TOTALLY DEFLATED
a
100 %
0 % 0 %
1
50 %
50 %
50 %
2
100 %
100 %
100 %
CADET SOLID : INFLATE THE KEEL
• Once the floor in assembled, start inflation of the keel (pressure = 240 mb).
Inflation is over: fit the valve caps tight (clockwise).
NOTICE :
A slight air-leak before screwing the valve caps is normal.
ONLY THE VALVE CAPS CAN ENSURE FINAL AIR TIGHTNESS.