27 / 109
ensure riding comfort. Transmission system: If it is found th at the driving speed has dropped significantly, it is recommended to
maintain and inspect th e CVT transmission system at any time, and replace it in advance if necessary.
●The initial maintenance should be carried out strictly in accordance with the above table, otherwise it may cause damage to
the motorcycle or other unpredictable failures.
●In order to keep your motorcycle running normally, it is recommended to provide services by a dealer or a qualified
maintenance organization. Improper maintenance or maintenance may cause damage to the motorcycle or other unpredictable
failures.
●Replacement of unqualified parts will cause accelerated wear of your motorcycle and shorten its service life.
●Check the brake disc, muffler, spark plug, coolant and other items after cooling down.
●Pay attention to protection when replacing brake fluid and coolant to avoid contact with skin and eyes and cause injury. At the
same time, it is necessary to avoid dripping onto the surface of the parts and damaging the paint or surface.
●The waste generated in the maintenance process, such as cleaning agent, waste engine oil, etc., should be properly disposed
of, and random dumping is prohibited to avoid environmental pollution.
●The items listed in the needle are used in regular environments. If they are often used in harsh environments, the frequency of
maintenance should be increased.
●Steering system, braking system, electronic fuel injection system, shock absorber and wheels are all key components, and it is
recommended to be carried out by a qualified maintenance organization.
E350 Air filter (filter element), air inlet
filter element
Step：
1. Support the motorcycle firmly
Prop up the motorcycle with the main bracket and put
down the side brackets, as shown in the figure.
2. Remove the left engine cover
a.Use 4# inner hexagon to remove theswell nailforair filter
decorative cover bottom plate.
b.Use 4# inner hexagon to remove the M6×14 bolt as
shown in the figure. The bolt here cannot be removed
temporarily, just loosen it completely.
c.Use 4# inner hexagon to remove the 3 M6×14 bolts as
shown in the figure.Use 4# inner hexagon to remove theswell
nail.
3. Remove the air inlet cover
a. Use a cross screwdriver to remove four self tapping
screws from the air inlet sponge filter element assembly.
Remove the air inlet sponge after removing the front shell.
Replace the front housing with a new sponge. Note that the
screws should be installed vertically and the torque should
not be too large. The sponge filter element at the air inlet
shall be replaced every 4000km (2485mile) or 15 months
(whichever comes first).
To Next Page
Loading...
Need help?
General
