Zoom F6 - 7. Use and to select Update, and press.; This starts the firmware update.; 8. After the firmware update completes, turn the power off.

6
7. Use and to select Update, and press .
This starts the firmware update.
8. After the firmware update completes, turn the power off.
©2020 ZOOM CORPORATION Z2I-4155-01
NOTE
・ During the firmware update, do not turn the power off or remove the SD card. Doing so could
cause the F6 to become unstartable.
・ In the unlikely event that a firmware update should fail, conduct the procedures from the
beginning to update the firmware again.