Selecting a Patch for Playing (Play Mode)
Selecting a Patch for Playing (Play Mode)
The volume control on the connected amplifier
should be turned down.
When using the unit on batteries
Plug a shielded cable into the [INPUT] jack.
When using the unit with an AC adapter
Plug the cable from the adapter into the [DC IN]
jack.
Turn the guitar amplifier on and adjust the volume to
a suitable position.
Set the Module selector to "PLAY".
The bank and patch number are shown on the display.
Immediately after turning the G1N/G1XN on, the unit
will be in play mode, regardless of the position of the
Module selector.
Turn power on
Set the G1N/G1XN to play mode
2
Directly switch a bank
4
Adjust the master level
5
Press the [BANK UP·TAP] key.
Repeatedly pressing the key cycles through banks in
the order A ... d, 0 ... 3, A.
With the G1N, using the foot switch (FS01) to switch
banks is also possible (
g
p. 18).
Operate the [VALUE] knob.
The master level setting appears on the display.
The master level setting applies to all patches. The
setting range is 0 – 98, 1.0. It will be reset to 80 when
power is turned off and then on again.
When using headphones, this knob adjusts the listening
volume.
Select a patch
3
Use the foot switches.
Press the [
] foot switch to call up the next higher
patch.
Press the [
] foot switch to call up the next lower
patch.
Repeatedly pressing one foot switch cycles through
patches in the order A0 – A9 ... d0 – d9, 00 – 09 ...
30 – 39, A0.
This section explains basic functions of the play mode.
HINT
HINT
HINT
To Next Page
Loading...
Need help?
General
