To Next PageTo Next Page
Need help?Do you have a question about the Zoom G1 X Four and is the answer not in the manual?
General| Brand | Zoom |
|---|---|
| Model | G1 X Four |
| Category | Music Pedal |
| Language | English |
Overview of key features including realistic sounds, intuitive controls, rhythms, looper, EQ, and battery life.
Create sounds intuitively using 5 buttons and 4 knobs, similar to stompboxes.
Quickly adjust EQ (Lo/Mid/Hi) and volume (Vol) for performance needs.
Use to select patches for performance.
Turn effects ON/OFF in a patch with footswitches.
Change effects used in a patch and edit effect parameters.
Controls the amount of selected effects in PEDAL category.
Connect the AC adapter to power the device on.
Connect via USB for computer operation and Guitar Lab access.
Connect your guitar to the INPUT jack.
Connect to a guitar amp or headphones via the OUTPUT jack.
Turn the Lo knob to adjust the level of low frequencies.
Turn the Mid knob to adjust the level of middle frequencies.
Turn the Hi knob to adjust the level of high frequencies.
Turn the Vol knob to adjust the overall output level.
Select patches to use when the device is in MEMORY mode.
Instructions on how to switch the device into MEMORY mode.
Methods for switching to lower or higher numbered patches.
How to switch between banks of patches using numbered buttons.
Adjusts the patch level using the Vol knob.
Instructions for switching the device into STOMP mode.
Use the SELECT button to choose which effect to control.
Press the footswitch corresponding to the effect to toggle its state.
Steps to switch the device into EDIT mode.
Use footswitches 1-5 to select the effect for editing.
Press the footswitch again to toggle the selected effect ON or OFF.
Use navigation buttons to cycle through available effect types.
Navigate and select effects by category.
Use knobs to adjust parameters assigned to them by the selected effect.
Press the SETTING button to open the main settings menu.
Press the CHAIN button to view and modify the effect chain.
Use footswitches 1-5 to select the effect to be repositioned.
Use footswitches 1-5 to choose the new position for the effect.
Procedure for saving current patch settings to a new or existing patch.
Use navigation buttons to select the patch number for saving.
Open the SETTING screen to initiate patch swapping.
Access the SAVE screen and change mode to SWAP.
Use navigation buttons to choose the second patch for the swap.
Open the SETTING screen to adjust tempo.
Navigate to the SETUP screen.
Use the Lo knob to set the tempo in Beats Per Minute (BPM).
Use the Mid knob to set AUTO SAVE to ON or OFF.
Use the Hi knob to set the PRESELECT function to ON or OFF.
Use the Val knob to set the BANK HOLD function to ON or OFF.
Select battery type for accurate charge level indication.
Use the Lo knob to select between ALKALI and Ni-MH batteries.
Use the Mid knob to turn ECO mode ON or OFF.
Use the Hi knob to set backlight to OFF, ON, 15s, or 30s.
Use the Val knob to set the display contrast from 1 to 13.
How to tune the guitar using the chromatic tuner display.
Select an effect from the PEDAL category for expression pedal control.
Calibrate the expression pedal for optimal sensitivity.
Follow on-screen prompts to calibrate the pedal's minimum and maximum positions.
How to view the system, preset, and boot firmware versions.
Check battery connection to the INPUT jack if using batteries.
Troubleshoot connections, effect levels, patch levels, output volume, and tuner settings.
Check cables and use a genuine ZOOM AC adapter to reduce noise.
Check for 'PROCESS OVERFLOW' warnings, which bypass effects.
Use correct battery types and settings; avoid manganese batteries.
Check pedal settings and adjust the pedal itself.
