Zoom G3Xn - Calibrating the G3 Xn Pedal; Calibrating Pedal Sensitivity; Adjusting Pedal Torque

42
43
Calibrating the pedal
■ Calibrating the sensitivity
• TurnthepowerswitchONwhilepressing .
• Operatethepedalasinstructedonthedisplay,andpress when
required.
• "Complete!"willappearbeforeplaymodebecomesactive.
NOTE
Calibrate in the following cases.
−Stepping on the pedal has little effect.
−The volume and tone changes greatly even when the pedal is only pressed lightly.
■ Adjusting the torque
• Insertthehexkeyintothetorqueadjustmentscrewonthesideofthepedal.
Turn it clockwise to tighten the pedal, and turn it counterclockwise to loosen
the pedal.
Loosen Tighten
NOTE
Be careful when loosening a torque adjustment screw, because if you loosen it too much, it could come off
inside the unit, making it impossible to hold the pedal in place.
Using the pedal