Zoom L6 - Page 21

Z2I-5404-01
ZOOM CORPORATION
4-4-3 Kanda-surugadai, Chiyoda-ku, Tokyo 101-0062 Japan
zoomcorp.com
Product names, registered trademarks and company names in this document are the property of their respective companies.
The microSDXC logo is a trademark of SD-3C LLC.
USB Type-C is a trademark of the USB Implementers Forum.
All trademarks and registered trademarks in this document are for identification purposes only and are not intended to infringe
on the copyrights of their respective owners.
Recording from copyrighted sources, including CDs, records, tapes, live performances, video works and broadcasts, without per-
mission of the copyright holder for any purpose other than personal use is prohibited by law. Zoom Corporation will not assume
any responsibility related to infringements of copyrights.
The illustrations and display screens in this document could differ from the actual product.
Troubleshooting
Sound is not output or the volume is
very low
→
Check the headphone and speaker connections.
→
Conrm that the output levels are not too low for
MONITOR, MASTER and each of the tracks.
→
Check the orientation of the mic or the volume
settings of the connected equipment.
→
Conrm that buttons are not lit.
→
If using a condenser mic, conrm that
is on.
Monitored sound is distorted
→
Use to adjust the volume.
Recorded audio is too loud, too quiet
or silent
→
The input audio might be too loud. Increase the
distance between mics and sound sources.
→
If using a condenser mic, conrm that
is on.
Recording is not possible
→
Conrm that the microSD card has open space.
→
Conrm that a microSD card is loaded properly in
the card slot.
The recorded sound breaks up
→
Use the L6 to format the microSD card.
→
We recommend using microSD cards that have
been conrmed to operate with this recorder.
See the ZOOM website (zoomcorp.com/help/l6)
for information about microSD cards that have
been conrmed to work with this unit.
Not recognized by computer when
connected
→
Use a USB cable that supports data transfer.
Date and time reset frequently
→
If power is not supplied by an AC adapter or bat-
teries for a long time, date and time settings will
be reset.
Connect the L6 with a computer again using a
USB cable (Type-C), and launch ZOOM L6 Editor
to allow the date and time to be acquired.
The send effect is not working
→
Use to adjust the volume of the internal
effect.
SOUND PAD functions cannot be used
→
Conrm that audio les have been assigned to
the sound pads.