2
2. Introduction
Thank you for downloading the “ZOOM MS-100BT System v1.30 Updater” application.
This document explains how to update the MS-100BT firmware.
3. Checking the MS-100BT firmware versions
Following the procedures on page 25 of the MS-100BT operation manual, check the
firmware versions of your MS-100BT. If the SYSTEM version is v1.30 or higher, you do not
need to use this application to update the firmware. If the system version is lower than
v1.30, follow the procedures below to update the firmware.
4. Updating the firmware
Before updating the firmware, if any applications are running, quit them all.
4.1. Press parameter knob 1 on the MS-100BT to open the MENU.
4.2. Select Bluetooth in the MENU and select PAIRING. Then, use the computer to pair
the MS-100BT as a Bluetooth device.
NOTE
For this update, leave PAIRING selected.
NOTE
There is no need to pair in the Bluetooth pane of the Mac System Preferences.
To Next Page
Loading...
