zortrax M Series Preparation For The First Use

First Print
Insert the SD card with the models stored on it into the printer. The models should be
saved in the main folder.
To choose the model for printing, select the “Models” option from the main menu.
Select the model in the .zcode format and confirm by pushing the knob.
The printing procedure will begin automatically.
The display will show information about the extruder heating level. Once the heating has
been completed, the M300 will start printing. The bar on the display shows the progress
of the print.
Do not leave the printer unattended during the pre-print calibration.
Powered by TCPDF (www.tcpdf.org)

zortrax M Series Specifications

General

Brand	zortrax
Model	M Series
Category	3D Printers
Language	English