zortrax M300 Maintenance Guide

Platform
ACTIVITY FREQUENC
Y
SOLUTIONS TO THE PROBLEMS NECESSARY
ACCESSORIES
Cleaning the
perforated plate
Before each
printing
process
To remove material remains from the
surface of the perforated plate, use a
spatula
– a spatula
Checking the
perforated plate
for deformation
Before each
printing
process
– –
Calibration Every 200
working
hours
If the platform calibration fails, move on
to the next step indicated in this table
–
Cleaning the
heatbed and the
underside of the
perforated plate
Every 300
working
hours
Unscrew the screws that secure the
perforated plate and remove the
residues from the underside of the plate
using a spatula. The heatbed needs to
be cleaned with a piece of cloth
damped in acetone
– a spatula,
– a piece of cloth,
– acetone

zortrax M300 Specifications

General

Build Volume	300 x 300 x 300 mm
Filament Diameter	1.75 mm
Nozzle Diameter	0.4 mm
Connectivity	SD Card
Operating System	Windows, macOS
Software	Z-SUITE
Printing Speed	up to 100 mm/s
Heated Bed	Yes
Nozzle Temperature	up to 290°C
Supported File Formats	.stl, .obj, .dxf, .3mf
Supported Materials	Z-ULTRAT, Z-HIPS, Z-GLASS, Z-PETG
Power Supply	100-240 V, 50/60 Hz