Zotac MAGNUS ONE

2
QUICK START GUIDE
PACKAGE CONTENTS
CUSTOMIZING YOUR ZOTAC ZBOX
• 1 x ZOTAC ZBOX
• 1 x Power Cord
• 2 x Nylon Cable Tie (optional)
• 1 x Warranty Card
• 1 x Quick Start Guide
• 1 x USB flash drive with Windows drivers
• 2 x Antenna
1. Lay the ZOTAC ZBOX on a flat surface.
2. Locate the two thumb screws and remove.
3. Press down on the arrow of top cover and remove
the top cover o the ZOTAC ZBOX in the direction
of the arrow.
4. Push up and remove the two side covers.
INSTALLING MEMORY MODULES
1. Lay the ZOTAC ZBOX on a flat surface with the right
side upwards.
2. Gently push down on the memory retainer clips to
the open position.
3. Insert a SO-DIMM memory module into the slot.
4. Gently push the SO-DIMM memory module down
into the slot until the retainer clips lock into place.
INSTALLING GRAPHICS CARD (OPTIONAL)
1. Remove the screw from the bracket.
2. Insert the graphics card into the available PCIe slot.
3. Install the screw to secure the graphics card.
4. Connect the power cable to the graphics card.
1 2
3 4
1 2
3 4
1
2 3
4