INTRODUCTION
Thank you for purchasing your ZRAY DRIFT Inflatable 2-person Kayak. Please follow these instructions for correct
assembly. Failure to follow these instructions may result in drowning or serious injury.
The ZRAY DRIFT inflatable kayak is designed for short trips over calm lakes, seas or rivers (less than 3 hours), and
is suitable for 1 – 2 adults.
PRODUCT DESCRIPTION
The ZRAY DRIFT inflatable kayak is equipped with two sets of paddles, two inflatable seats, double action high-
pressure inflating pump, backpack, fin and a repair kit.
The ZRAY DRIFT kayak has 3 air chambers comprising two side air chambers and a bottom air chamber. The two
seats are also inflatable.
WARNING
This is not a life saving device. Use only under competent adult supervision. When not in use do not leave
unattended near the water.
Read the owner’s manual thoroughly, ensure your understanding and follow the instructions. Keep this manual
for future reference.
Review the Government’s Boating Safety Guidelines to ensure you have the relevant equipment and most up to
date regulations. http://www.tc.gc.ca/media/documents/marinesafety/TP-511e.pdf
Do not exceed the maximum load capacity. Overloading can be dangerous and voids the warranty.
For use only in lakes, rivers and calm seas. Do not use for white water rafting.
Distribute the weight of paddlers and accessories evenly through the boat.
All persons must wear a PFD (Personal Floatation Jacket)
Ensure all persons are aware of the regulations and safety instructions before use.
INSTALLATION
Hull inflation:
1. Open and spread the kayak so it is flat. Check to make sure that the air valves and are in the ‘inflate’ position
and the two automatic bottom drain plugs are closed.
2. First, inflate air chamber ① and ② by 10% – 20% and be sure that both sides of the air chambers are evenly
To Next Page
Loading...