inflated. (Figure 1)
3. Ensure the floor is smooth and flat at the bow before inflating the sides.
4. Inflate air chambers ① and ② by 100% (8PSI), respectively. Make sure that both sides are inflated evenly.
5. Inflate air chamber ③ by 100% (8PSI).
6. If both sides of the hull are not even, adjust the air volume of air chamber ① and ②.
Hull installation:
1. . Inflate seats until your hands feel that the seats have been inflated by 100%. Be sure they are not over-inflated
or they could burst.
2. Install seats. Note, the rear seat is attached to the D rings nearest the stern so that the seat is as far back as
possible. The second set of straps will sit unsecured behind the seat. (See figure 2)
3. Install footrests into the loops on the floor of the kayak.
4. Install fin – remove the bar in the sleeve, slide the fin in and then secure it with the pin.
5. Assemble paddles.
PREPARATION BEFORE DEPARTURE
Ensure you know and understand the local laws, regulations and hazards associated with water sports and
inflatable kayak operations.
Please check local weather forecasts, local currents, tides and wind conditions before use and only paddle in
calm conditions.
Regardless of the weather conditions, you must wear PFDs in good condition and in line with local laws and
regulations.
Learn about the basic safety self-help methods: How to flip the kayak over. How to get on the kayak again.
Tell someone when you plan to return.
Ensure all passengers understand the basic operations of the inflatable kayak.
Make sure at least one passenger can operate the inflatable kayak in an emergency.
Wear suitable clothing (helmets, shoes, sunscreen). Take enough water and food and towing cables along with
all items required by law.
IMPORTANT SAFETY INSTRUCTIONS
The following should be read and understood before use:
1. Warning: Water sports are dangerous and require physical fitness. Users of this product must be aware that this
sport may result in injury or drowning.
2. Warning: Pay attention to offshore winds and underwater currents, which may cause the kayak to become
unstable.
3. Warning: Inflating the product should comply with the instructions. Do not over-inflate – over-inflation of the
product may cause the air chamber to burst.
4. Warning: Under all circumstances, keep the weight on the kayak balanced in case the kayak overturns. Do not
overload, check the weight specified on the product label.
5. Warning: Take extra care when boarding or disembarking the kayak. Falling between the kayak and dock can
be dangerous and may result in serious injury or drowning.
6. Warning: If you want to dry the kayak or expose it to sunlight for a long time, please deflate the kayak properly
first. Heat causes the air to expand and may cause the kayak to burst.
MAINTENANCE
1. After use, please clean your inflatable kayak to prevent it from being damaged by sand, salt water or sunlight.
2. Clean the inflatable kayak with a soft detergent and water.
3. Do not use solvents such as gasoline as they can corrode the surface materials or plastic parts of the kayak.
4. Make sure that the hull is completely cleaned and dry before storing otherwise it may develop mold.
5. Once deflated, fold the kayak, place in the backpack and store in a dry, ventilated place above 15°C.
REPAIR
Small holes or punctures can be repaired with the repair kit that is provided in conjunction with the kayak.
To Next Page
Loading...