1. Do not inflate the kayak
2. Wipe the hull with soap and water to find holes in the kayak. The soap will bubble over the hole.
3. Clean the area around the hole with water or alcohol.
4. Use a pencil to sketch out the outline of the patch.
5. Cut a patch of a suitable size.
6. Apply glue evenly to the damaged area and patch and then press and hold the patch to the damaged area.
7. Leave the kayak for at least 24 hours or more before inflating it.
Figure 1
Figure 2
Valve Replacement
If the valve is damaged, please follow the below instructions for replacing it.
To Next Page
Loading...