02418V10 • 11.08.2016/DC • 1-11
Installation
1.7 Installation
1.7.1 Electric installation
It has to be guaranteed that the automatic winder is connected to
a main supply corresponding to the electrical data of the winder
(see type label on the rear side). The rocker switch (rear side) has
to be adjusted in position ‘O’ before the main plug is plugged in.
• Plug in the rubber connector of the
power cord in the connector socket of
the connector-combined panel on the
rear side.
• Plug the power cord into an adequate
main supply with the necessary
connected loads
To Next Page
Loading...