ZSK Automatic Bobbin Winder - Page 13

02418V10 • 11.08.2016/DC • 1-13
Threading winder
• Operate the thread through the wire
eye of the switch contact spring.
• Run in the thread through the upper
thread guide of the front tension
regulator.
• Pull the thread from the right to the
left in between the curved washers.
• Run in the thread through the lower
thread guide of the front tension
regulator.
• Pull the thread through the movable
hook loop.
• Open the winder cover.
• Operate the thread top down through
the thread bow.
• Run in the tread top down through the
needle.
• Pull the thread using forcepts thus far
through the needle, until the thread
sag some centimeter underneath the
needle