1-14 • 02418V10 • 11.08.2016/DC
Winding process
1.9 Winding process
1.9.1 Start winding process
• Charge the bobbin depot with empty
bobbins.
Removing of bobbin depot cover is to be performed only if the
plug has been removed from the mains socket. Operation is allo-
wed only when covers are mounted and closed.
• Switch on the rocker switch on the rear side, position ‚I‘.
Handle with care operation push button JOGGING. This is a
setting mode with winding, cutting and clamp mechanisms which
perform movements also when the cover is opened. Ensure when
using this mode that no clothes, hair, rings, chains etc. plus
extremities are not close to moving parts. There exist the risk of
cutting damage and contused wound, as well as burn, abrasion
and catching through rotating parts.
To Next Page
Loading...