ZXDSL 831/831B/831II/831BII User’s Manual
10
Rear panel
Figure 3.1-2 Rear Panel of the ZXDSL 831/831B/831II/831BII
Table 3.1-2 Description of Interfaces on the Rear Panel
Item Introduction
DSL
RJ-11 connection interface: The equipment is connected to the ADSL line or
splitter via the telephone line.
Reset
In the power-on state, you can restore the system to the default configuration
by using a thin needle to press this slot for three seconds or for three
executive times.
Ethernet
RJ-45 connection interface: Connect it to the PC computer or other network
devices using the network cable.
Power switch
PWR
Power interface. Connect it to the power adapter.
3.2 Hardware Connection
Connection 1
The following connection method is recommended. Figure 3.2-1 shows the
connection between a ZXDSL 831/831B/831II/831BII, computer, splitter and
telephones.
To Next Page
Loading...
